Spa Drains Into Pool When Turned On

Spa Drains Into Pool When Turned On. It seems if i have enough water in the pool this does not happen. If i turn jandy valve to send water back to the pool via the water feature the system will hold water.

Why Does My Spa Drain Down When the Pool Pump Shuts Off from dengarden.com

This will help the flow between the pool and spa. It looked like it was draining into the pool. Spa drains into pool post by kev » sun 04 may, 2008 10:33 i have the same problem, although my system is manuel.

Source: winecountrypools.blogspot.com

In a traditional commercial pool or spa, a main drain works off of suction created by the poo or spa's pump. When we turn the spa off, the system goes back into pool mode which merges the warm spa water into the pool so that no energy is lost.

Source: www.troublefreepool.com

It also sounds like the valve is set to draw all the water from the spa and and the return valve actuator is set to return the water to the pool.causing the spa to drain. It seems if i have enough water in the pool this does not happen.

Source: dengarden.com

So say it is cracked open, out of the heater it goes to the jandy never lube valve and say 80% of the clean water will go to the pool and 20% will go to the hot tub/spa. Basic pool or spa plumbing systems.

Source: www.inyopools.com

If it's a jandy actuator.you should be able to remove the thumb screw on top of the actuator that holds on the handle.then remove the 4 screws with a #3 phillips screwdriver. So say it is cracked open, out of the heater it goes to the jandy never lube valve and say 80% of the clean water will go to the pool and 20% will go to the hot tub/spa.

Source: www.justanswer.com

Water flows from spa and the pool's main drain and skimmer to the pump to be filtered and returned to the pool since no water is returning to the spa, it will eventually empty. It too heats up in 15 minutes, no advance planning required.

Source: winecountrypools.blogspot.com

Up to 20% cash back ok, well, it may be difficult to locate the exact problem, but basically what is happening is that when it's in the spa mode, it is sucking water through the spa drains and skimmer and instead of it all going back into the spa, one of your pool return valves is staying open or has a bad sealing gasket in it and is allowing the spa water to be pumped back. So these are the most common things that will cause your spa to drain down when the.

Source: dengarden.com

If your spa drains down after the pool turns off chances are it is a check valve failure. A pool heater will only operate when the pool circulating pump is turned on).

Source: spa-pictures.blogspot.com

It seems if i have enough water in the pool this does not happen. Turn the spa suction valve to the “off” position and make sure you have the spa return valve at least partially open.

Source: www.lvnvacationhomerentals.com

First of all make sure your valve actuators are sync'd up correctly now.aka when in spa mode its pulling and adding to the spa and pool mode its pulling and adding to the pool.then from there if the problem persists as it sounds it will.then install a check valve on the return side as everyone else has said. If there's a problem with the actuated spa valves, you get into a situation where the spa drain is active, but the outflow goes into the pool.

So Say It Is Cracked Open, Out Of The Heater It Goes To The Jandy Never Lube Valve And Say 80% Of The Clean Water Will Go To The Pool And 20% Will Go To The Hot Tub/Spa.

Draining while the motor is running. When we turn the spa off, the system goes back into pool mode which merges the warm spa water into the pool so that no energy is lost. If i turn jandy valve to send water back to the pool via the water feature the system will hold water.

I Am At A Complete Loss As To Where My Trouble May Be.

I lookeda t the panel and it looked normal. Up to 20% cash back ok, well, it may be difficult to locate the exact problem, but basically what is happening is that when it's in the spa mode, it is sucking water through the spa drains and skimmer and instead of it all going back into the spa, one of your pool return valves is staying open or has a bad sealing gasket in it and is allowing the spa water to be pumped back. The spa has a set of drains which are also enabled at the same time, so the spa water is isolated from the pool.

The Spa May Be Plumbed Either With A Separate Pool Return In It Or Have Water Sent To The Spa Jets.

If there's a problem with the actuated spa valves, you get into a situation where the spa drain is active, but the outflow goes into the pool. In a traditional commercial pool or spa, a main drain works off of suction created by the poo or spa's pump. It too heats up in 15 minutes, no advance planning required.

A Pool Heater Will Only Operate When The Pool Circulating Pump Is Turned On).

3) turn on the pump if it’s not already on. The only problem she had she turned the hand valve on the return line the wrong way and broke the stop on it. You set the thermostat to the desired temperature and the heater turns on all the way and continues running until the desired temperature is reached, and then turns off, (note:

Worked Fine Until A Few Days Ago, My Wife Used The Spa.

Doing this will turn the spa return on and the pool return off. Is your pool spa draining into your pool when pump is off ?there could be few things.1, the reason could be your settings if you have an automated system.2. The suction valves need to be adjusted properly.