Why Is My Dolphin Pool Cleaner Not Working
Why Is My Dolphin Pool Cleaner Not Working. 11 rows pool cleaner is moving in circles. Check that the power supply cable is plugged properly into the power supply socket.
With the industry’s best robotic pool cleaner warranties and. Output voltage should be about 38 volts d/c. Subsequently, question is, why is my dolphin pool cleaner not working?
Follow These Steps And Troubleshoot Your Maytronics Dolphin Pool Cleaner Quickly.
Finally getting this started up.!st time with dolphin e10 , i must say, not impressed so far unless i expect too much. Do not allow the power supply to be submerged in the pool. Check power to the socket and reconnect pool cleaner.
If The Cord Is Okay, It Could Be A Mechanical Problem Inside The Cleaner.
If the meter shows 29v, you are getting power to the motor. Then place the meter probes into the plug on the motor end of the cable. I believe this circuit board is one of the few user parts available.
Wait 30 Seconds Then Turn It Back On.
It could be an issue with the motor, tracks, belts or one of the many parts involved in a pool cleaner’s movement. Add or remove additional lengths as required. If this sensor malfunctions for what ever reason, the unit won't run and the motor has to be replaced.
Ensure The Hose Weight Is Approximately 1M Away From The Cleaner Head On The First Length Of.
See if there are any rips or tears in the cord that may be causing a short circuit. Then place the meter probes into the plug on the motor end of the cable. It may not be plugged in properly or there may be a problem with the power supply.
Pull Out The Filter Basket And Check For Debris That May Be Interfering With Water Flow To The Pool Pump.
However, it is safe to use a surge protector with the dolphin. Debris stuck in the impeller. Turn on the power supply.
Post a Comment for "Why Is My Dolphin Pool Cleaner Not Working"